Hello everyone. So
in this video we are going to see how can
we exclude host from our
Network into our scan?
so as you can see the command that I
have typed is nmap the
subnet
and hyphen hyphen exclude this particular host
from scanning, which is 192 168
43 dot 213.
and hyphen V which means
show me the output in verbose mode.
So now I will hit enter and you can see the scanning
has started successfully.
So let's wait for the output and see.
As you can see the scan has completed successfully. Let's check
for the host. That was two and three.
As you can see two one two and two
one four, which means two one three has
been excluded from this specific scan.
Let's go down and check.
As you can see, I've only identified The Two Hosts
are up. This is the first host and this is
the second host which is the router. So we have successfully excluded
the host that is 213 from
our scan. So remember
the syntax of doing this scan is
hyphen hyphen exclude and any IP
address that you want to exclude from the
Network, for example I give your X
instead of X you have to type any IP
address that you want to exclude from
the scan
X
needs to be replaced by the IP address that you
want to exclude.
So I hope you guys understood this. Thank you.