Hello everybody and welcome back.
And here I am right now on my laptop which I will use in order to show you this process of gathering
the four way handshake from a wireless access point.
Now as I said I am using the laptop because I have my father's network card and put in monitor mode
right here or basically I have the option to put it in monitor mode right here and on my clinic's machine.
I don't have that option.
So once again if your card cannot be put into a monitor mode you might you will need to buy a different
card which can be found cheap online or just 10 dollars.
And then you will be set to go.
Now before we begin with the attack itself we show you how to put your card into monitor mode or basically
how you can check if your card can be put into the monitor mode.
So once again if you are on the clinic's machine make sure you first off connect your wireless adapter
and your wireless networking card.
And once you do that basically the process is the same for me and for you.
So let me just enter my mind right here.
Just open up your terminal and basically type their IV config.
Once you type that you will see your available networking interfaces and you will see your wireless
networking interface which basically for me right now is W 0 0 0 1 now for you it will probably recall
something different.
So make sure you remember that name since you will specified in every comment you use from now on in
this section.
So in order to first of all check which mode your my your card is in which mode your card is at the
moment.
Just type in your terminal IOW config and it will show you that your wireless networking card is currently
in the managed mode.
It is in that mode by default and it used once you just surf the internet and basically do anything
else.
When once you connect to device access point but we do not want to our exploit me our network card to
be in managed mode we want it to be in monitor mode.
Now in order to put it in monitor mode first of all you need to send your card your networking interface
down which you do with this command.
So I have config and after that you type space and then the name of your network card which in my case
is w l 0 1.
Now in your case it is probably something different so make sure you specify your networking card interface
instead of mine.
If you just copy this command it will not work for you so after you type your networking card interface
name it after that just type space Intel down.
This will it.
And once you PRESENTER This will send your network interface down.
And as you can see right now I will not be connected to the internet since I put my network interface
now and you will also not be able to see it once you type the IV config comment.
Now right now what we want to do is since we put it down we want to put it into monitor mode and how
we do that.
We do that with this command.
I w config then space than the name of your network card which in my case is W L O one and then type
after that mode monitor.
So just like that.
Just press enter and if this command executes without problem that means that your network account can
be put into monitor mode and you should be good to go if you have problem running this command or it
doesn't want to execute you will need to buy a new network account has monitor mode option in it so
if you did all of this and it worked the next thing you want to do is put your network kind of interface
back up so type here I've config w 0 1 and then up and once again as we can see in the previous command.
Once we run a W config it gave us that our networking card is in demoed managed.
But now if we type that once again I w config we can see that currently our card is the monitor is in
the monitor mode.
So that's how you put your card into monitor mode.
And if this indeed you executed this without any errors you're good to go and we will continue with
the attack in the next lecture and hope I see you there and take care bye.