Great, so we attach Carly to our network physically now we have to make the configurations to make
Carly a part of Valentin.
So as you can see here, my colleague is not running at the moment, I'll go to switches console to
configure the connection.
It'll be similar to configurations of the VPC.
Type can't tea.
To enter the configured terminal mode.
And then into F1 three to configure the interface fast Ethernet one, slash three, which is used for
Colly.
We have seen these before, so I'll just go through it quickly, switch mode access.
Switchboard Access Vilan 10.
No shutdown exit.
Exit again, go to the root, and you are to write the configuration to make it persistent, OK, to
check the current situation of the interfaces we can now use, show IP interface brief.
Here's the interface of Colly fast Ethernet one six three, it's supposed to be up is shown here.
However, if you stopped the switch and started again, your interface is probably down for now.
As you can see here, my fast either net one for interfaces up, which is supposed to be down because
nothing is connected to it.
So I added another VM and removed it while I wasn't recording.
That's why it looks like this.
So let's restart this switch.
What's expected at the end is your colleague Port will be up and my F one for port will be down.
So I click on SWICH Select, Stop and right click again and select start.
Which is up, let's look at the interfaces again, open console, the switches initializing.
Showup, interface, brief.
And as you see faster Ethernet 1-3, the interface of my colleague is of his expected EF one slash four
was up before the restart and it's down now.
And that's the expected result to.
So I suppose your colleague Port was down before the restart and it's up now, if not, just go back
and do the steps again.
So now let's go to college and configure it, since we don't have a DHP in our network, we have to
assign the IP addresses for the node of the network manually.
So I click on Collee and select start and Collie's started and it's initializing.
Log in with user, my password is still tío or.
OK, first, I want to check the network interface inside Colly.
On the upper right corner, right, click to the network icon and Ethe Zero is selected.
That's exactly what I want.
Now, the double check, I'll go to the network interface from VMware menu and yep, there it is in
custom mode, just as I wanted.
Now, as I mentioned before, we have to assign the IP address, subnet mask, Gateway, et cetera,
manually.
So, OK, that terminal and we'll use if config to configure is zero.
All right, so if config the interface either zero, the IP address for Colly, I'll choose one nine
two two one six eight eight one zero three.
Subnet mask 255, dot 255, got 255 zero and hit enter now to check the network, let's ping the router
first.
It was one nine two dot one six eight nine one zero one.
And yep, there it is.
We got the reply packets and that's a good thing.
Now you can use control C to quit the Pinkman.
So let's ping another device in the same network, the VPC, its IP was and to excellent, right.
So now just a triple check, let me go to the VPC and Ping Colly from their.
The IP of Colly is ten point three perfect, and we've got the reply packets to prove it.
Let's go for a quadruple check.
OK, so I'll go to the Rooters Council and Pinkly.
The success rate is 100 percent, so as you see, the ping result is given in a different format in
the router, and then the result is, again, just as we expected.