Okay.
Now, when we open the MSB console, as we learned previously.
Now here we will use the show command dash edge.
This is to show us, as you can see, we can see that we have the command and the valid parameters like
encoders, exploit payload auxiliaries, both plugins info options.
Favorites.
Whatever.
Okay.
So these are actually the categories for the Metasploit framework.
All right.
So we will use the use command, use command, and we will use the auxiliary this time.
So from here, slash and we will use scanner slash.
We will use a board scan slash TCB.
Yeah.
So we are using from the auxiliary scanner, port scan, DCP OC.
Now we are selecting the auxiliary scan.
Scan now to unselected or D selected.
We will use the back command or the previous command.
So back you can see that we are not using anymore.
Here it is.
We are not using anything again.
Let's use it again.
Now, this time we want to use not TCB, we want to use sync, for example, or something like that.
So if I type back.
You can see that it will return back to the previous OC to to without using anything.
Now another command which is using the previous.
So you sync then use TCB.
Now if I type previous like this, you can see that I was on the TCB before I used the same.
Now I from the TCB, I returned back to the previous one, which is the sin.
So back to return back to not using anything as you can see.
But the previous will show us the previous option or the previous usage.
So previous.
If you keep pressing previous, you can see that it will show us the previous module we are using.
Now, in our case, we want the TCB show options.
Now, this is another command to show the options for this auxiliary.
So you can see that the options the concurrency delay jitter as you can see.
Are the ports, the host threats, timeout whatever.
Now we want to change or to set this value the our host.
So we are using the CET command.
So set our host and put the IP address of the victim machine.
So let's use this one, for example, or use whatever we want.
Actually, in my case, I want to use my IP address, which is this one.
By using by the way, I'm using IV config command.
This is to show us the information about the interfaces, which is this one and this is the IBI.
So I will put it here.
Like that.
And now we are using auxiliary this auxiliary the bots can TCB for this host.
Now we want to run it to run this.
So run and it will start scanning for bots.
Now you can see that it has completed the execution of the module completed and we have this bot TCB
22, the such and HTP TCB which is 80.
All right.
Cool so far.