Hello and welcome.
Now, most of you know that E.S.P board has built in touch sensors, so you will take the readings from
three dozen sensors from our ESB board.
And to do that, we have touched sensors on pins, two, four and 15.
So go to the LUB.
And here you can simply write in your request.
A sort of sense of value, one you can split it with.
Dutch
Reed, which is basically.
A function that would take the PIN number for attached sensor.
So this is our first touch sensor.
And for value, too, we will try to read
the second sentence is up, general-purpose input output number four and the third since or watches
touch read
number 15.
Now, let's upload the code again.
We will make sure that our Web page will display the reading from these three touch sensors.
You can replace this with any other sensor so there is no limit here.
You can add more sensors.
You can add more elements to the table.
It's up to you now.
There's a lot of opening for.
OK, let's touch the ball again.
Click, upload again and wait a few seconds until the code is compiled and uploaded to our E.S.P board,
and let's get our page ready, as you can see.
This is our page, the request page, and it did take a lot of values, as you can see here.
Now, in a sort of value, one value to add value three.
We will get.
The sensor values.
So it will be more useful to get sensors reading here now than uploading let's refresh the page.
OK, as you can see now we have sensors reading.
As you can see, this is the first touch since all of this is the second one and this is the third one.
Every 30 seconds, we will get new sensor readings.
I will refresh the page, as you can see now, we have new readings, you can add other sensors, you
can change this to be a temperature sensor,
humidity sensor or any other type of sensors.
Sky is the limit here.
Again, all of the codes and everything will be Atash the course material.
If you have any question regarding anything, I'm here to help you.
Thanks for watching.
This is Asharaf from educational engineering team.