So this is outlines his thoughts and be untied and uh to some earlier some of those things first identify
the base by testing
collector the metal.
As I mentioned earlier we can identify the base by destroying the two terminals.
That gives no reading when connected with the two probes of the distal multimeter.
As we did earlier this week the two terminals that gave no reading so that failed.
Ben will be the base now.
After identifying the base end the fight type identify type and be on or be on B depending on the latter
in the middle.
If we collected that it brought to the base and it gave reading with the C and E so it's and beyond.
If we connected the negative or the black blob to the base and it gave reading with the collector unlimited
its B and B the one that we have here give reading with when we collected that in the probe to the base
and the black blob to the collector on the mantle would give readings.
So it's and b untied the third and final step would be test base to emitter base to collect.
This should give higher reading on digital multimedia so the one with the higher reading is basically
diameter.
And this is this is what we have done.
What we did here.
That's the emitter.
This did not give us like six hundred eighty nine.
And this gave us six hundred seventy five.
So it's a very slight level over a small difference but it's there.
So this one is the image out and this one is the collector.
As we mentioned here base lift.
So that's it.
This is how to test out a transistor using a digital multimeter.
If you have any question please ask and background label.
I'm here to help you.
This is education.
Engineering team thanks for watching.