So now we're on the last step.
Fix the problems and run.
Carly.
Now, in this lecture, I will assume that you do have trouble with network connections and I'm going
to give you some solutions so that you can fix the problem.
Now, hopefully you're not facing such a problem.
So if you don't have a network situation, please, you don't have to apply any of these solutions in
this lesson.
But it's good to have you on the ride and you can always sharpen your troubleshooting skills.
So first office reboot the machine to understand whether the problem is an exception for the initial
run or not.
So I shut down the virtual machine because I want to look at the settings.
Now select Caleigh and click the settings button and click this system tab.
I want to make the RAM three gigabyte.
So now I can click the start button to boot it again.
Username and password are both Kelly.
OK, we are in again.
So let's check the network connection by clicking the network icon at the upper right hand corner.
So I think there's a problem on the DHC p of the VM where you are.
Anyway, we can live without DHS, S.P. as well.
So I'm looking at the Wired network.
Don't be confused, even though you share the wireless connection of your host machine.
It's simulated as a wired network in the VM.
So let's open a terminal screen and look at the networking service if it's running right.
Service, networking and press tab twice to see the available commands of the service.
Networking service does not have status command.
So I'll assume that it's not started and try to start it.
And if you are still not connected at this point, let's go to network settings.
You can go to network settings via advanced network settings under the menu.
Or you can right click on the network icon in the upper right corner and select edit connections.
Now click the wheel icon under the wire tab.
OK, OK, I go to the IPV for tab to set the IP manually, click the manual option.
I'll choose an IP for the new COLLY.
Now, the IP block of my virtual network is 10 and zero two zero through 24.
So I'll choose an IP from this block.
Net MASC is two five five dot 255 got two five five zero four twenty four IP block.
The gateway is tender, zeroed out to, dark to.
So I can use Google DNS as my DNS server and route.
Now you can click the Saban.
OK, I'll reboot the machine to be sure that the changes are applied.
Who completed?
So open the terminal screen and first type pseudo as you switch, which they use it a route so that
you don't have to write pseudo forever command that requires privileges and then run the F config command
to see the IP address of Kelly.
And it's 200.
So let's ping a remote system, for example, Google DNS eight eight eight eight eight.
Yes, we will see the response packages.
And that works okay now.
So to double check, open a browser and visit any Web site.